Solution for FLOPPY DISK fail (40) Error message??
Usually this error already well known for his reputation for throwing the notice "FOPPY DISK fail (40)", which the same you is indicating that there is a spontaneous error in your floppy disk drive, the causes can be many but then we will show how I've solved it with other people
This type of failure is caused by the drive, and to be able to resolve it must enter the BIOS and change boot preferences, putting first-choice our hard disk booting.
Usually this error already well known for his reputation for throwing the notice "FOPPY DISK fail (40)", which the same you is indicating that there is a spontaneous error in your floppy disk drive, the causes can be many but then we will show how I've solved it with other people
This type of failure is caused by the drive, and to be able to resolve it must enter the BIOS and change boot preferences, putting first-choice our hard disk booting.
1- entering the devices managed (start right click on computer properties Device Manager) and verifies that there is a yellow exclamation mark sign next to floppy disk reader. If present, reinstall the driver
floppy disc fail 40, error message, pc, windows, solution for error
2- enter the Bios. If you notice that your reader of floppy disks (floppy disk Drive) is in first position in the sequence of boot (Boot Sequence), change it
and put your hard drive in the first place (1).
3- enter the BIOS and select disabled or Not Installed in the reader A floppy, saves the changes with the F10 key and restart the PC.
4 -check that the floppy drive is properly connected
5. If the problem persists: disconnect or remove the floppy disk drive of the PC.
In this way, you can solve the problem that you've been resolving with your problematic drive, also is worth mentioning that you must be careful when making these steps already, often by a mistake of removal or update can ruin everything.
Even if you remove the cable from the floppy drive and even though you don't have floppy drive you can leave that message in the Bios if it has misconfigured, and has returned to factory settings where the floopy is activated by default, and just having no floopy is to when get this message since it gives it failed.
Boot enter Bios (Setup), load optimal defaults (Setup default optimized values), then (without leaving the Bios) sees the first screen (where is the clock) see below the option "floopy disk" put it on "disabled" or "none" (this depends on the Bios), and gives F10 to exit saving changes. And reboot to see if it has gone the problem
Turn off and disconnect the pc, and cold-start again, you back out the screen, you'll need to replace the battery on the motherboard because it is surely dead
In this way, you can solve the problem that you've been resolving with your problematic drive, also is worth mentioning that you must be careful when making these steps already, often by a mistake of removal or update can ruin everything.
Even if you remove the cable from the floppy drive and even though you don't have floppy drive you can leave that message in the Bios if it has misconfigured, and has returned to factory settings where the floopy is activated by default, and just having no floopy is to when get this message since it gives it failed.
Boot enter Bios (Setup), load optimal defaults (Setup default optimized values), then (without leaving the Bios) sees the first screen (where is the clock) see below the option "floopy disk" put it on "disabled" or "none" (this depends on the Bios), and gives F10 to exit saving changes. And reboot to see if it has gone the problem
Turn off and disconnect the pc, and cold-start again, you back out the screen, you'll need to replace the battery on the motherboard because it is surely dead
Did you like the article? Share with us and the community and give us your opinion, and Remember to visit our website and find out about more problems and common solutions on current technology and much more, CLICK HERE...
